Pearson 70 User Manual download pdf (Page 18)

Scanner Installation

Preparation

2-2 Installation Guide for the OpScan iNSIGHT 70 Scanner

Software

The following software components are required:

• Microsoft

Windows XP

operating system software

Documentation: The appropriate Windows operating system user’s guide

• Scanner application software

Documentation: ScanTools

Plus User's Guide

• Scanner Exerciser diagnostic software (or equivalent)

Documentation: Operator's Guide for the OpScan iNSIGHT™ 70 Scanner and

Maintenance Manual for the OpScan iNSIGHT™ 70 Scanner

Installation Sequence

The installation sequence for the OpScan iNSIGHT 70 scanner is:

1. Check the installation site to verify that it is ready for setup and installation of

the scanner with its computer, monitor, keyboard, and mouse.

2. Install the scanner.

3. Install the computer, monitor, keyboard, mouse, and furniture.

4. Check the voltages.

5. Connect the network cables (optional).

6. Configure the internet network addresses and test the network (optional).

7. Verify that all software has been pre-loaded.

8. Run the Scanner Exerciser Utility to check the following:

• Sheet feeding (See Scan Sheets menu).

• Selecting and printing (See Scan Options menu).

• Color selection (See Configuration).

9. Run Scanner Exerciser to check alignment (See Check Alignment).

10. Run the appropriate Camera Setup utility

to check and adjust camera/mirror

alignment and focus.

11. Run the Normalize and Calibrate Utility on the scanner.

12. Run sample application using ScanTool Plus.

13. Power off the system.

The above installation sequence and the following instructions serve as a typical

step-by-step guide only. They may not exactly fit your setup.

1. For detailed information on how to run Camera Setup or Fast Camera Setup, refer to the Maintenance

Manual for the OpScan iNSIGHT 70 Scanner, Chapter 3.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 47 48

No comments

Pearson 70 User Manual Page 18